Boat Details

41 Custom Aluminum CC Sloop



Yacht World Number: 2697326
Located in La Paz, BCS, Mexico
Year: 1977
Hull Material: Aluminum

Excellent oportunity to own a great ALUMINUM HULL center-cockpit cruiser that has given us many fantastic memories. This design is so easy to sail and has such a pleasant ride both while passage making and at anchor.  With the cutter-rigged sloop you can get a good turn of speed in light winds and also reef down and balance the sail trim for any rough weather you might run into.  The Hull was built at the All-American Yard in Tacoma Washington in 1977 and the first owner took quite some years to finish the interior build out because he was a profesional Charter Captain in the Carribean. this boat was kept in Seattle for many years with a nice fresh water wash-down every few days… and often stored out of the water.    Don’t wait to start enjoying the Cruising Life, Go Now!

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.

La Paz Yachts
Division of Mazatlan Marine Center
Tom & Cindy
Marina de la Paz
La Paz, BCS, Mexico 23000

Toll-free 1-855-225-2729
Other Local (612) 123-1948



LOA: 46 ft 0 in

Beam: 12 ft 6 in

Minimum Draft: 5 ft 2 in

Headroom: 6 ft 2 in

Dry Weight: 36000 lbs


Total Power: 56 HP

Engine 1:

Engine Brand: Isuzu

Year Built: 1985

Engine Model: C-240

Engine/Fuel Type: Diesel

Engine Hours: 1498

Propeller: 3 blade propeller

Drive Type: Other

Engine Power: 56 HP


Fresh Water Tanks: 4 (120 Gallons)

Fuel Tanks: 3 (150 Gallons)

Holding Tanks: 1 Aluminum (25 Gallons)


Large V-berth with 2 twin beds plus large drawers, hanging locker, walkthrough with head on port side, cabinet and drawers on stbd side, spacious main salon with sea-berth and 2 large settees that convert into additional bunks, galley with double basin stainless sink and large drawers on portside of offset companionway, large chest freezer stainless lined with holding plate and spill over section, walkthrough to aft cabin on stbd side with room for additional storge, aft cabin with custom queen matress and stainless sink & vanity, secondary companionway, enterance to engine room and workbench. large lazarette with water-tight bulkhead with access from aft deck.


Galley is very user friendly with nice large drawers and a slide out cutting board/food prep that extends about 3 ft. a large deep stainless double basin sink with storage underneath, 2 opening portlights for additional ventilation.

  • REFRIGERATION: Adler-Barbour 12v “cold machine” with optional sea-water cooling circuit new in 2005
  • FREEZER: holding plate with spill over section
  • WATER SYSTEM: demand 12v
  • WATER HEATER: 6 gal stainless 110vac/engine heat, new in 2005
  • STOVE: Forceten SS 3-burner with oven gimbaled converted to propane from Kerosine age unknow
  • COOKING FUEL: propane
  • SINK: 2 basin SS
  • OTHER: large pull-out cutting board, laminated solid wood

Navigation and electronics

  • GPS, autopilot, radio, and tridata purchased in 2005
  • VHF: Standard Horizon
  • GPS: Garmin 72
  • RUDDER ANGLE: W-H autopilot
  • STEREO: am/fm/cd
  • DEPTH SOUNDER:  Raymarine tridata
  • HAILER: built in to VHF
  • AUTOPILOT: W-H Autopliot


New Blue Sea Systems panels and new wiring throughout in 2005

  • HOUSE BANK 1: 3 of type 4D AGM with 200 amp-hours
  • START BANK: 1 of type group 31 lead acid
  • OTHER BANK: 2 of type group 24 AGM
  • ALTERNATOR: 65 amp
  • SMART REG: solid state
  • OTHER: contoller for wind gen installed/wired


  • BILGE PUMP: 2- rule 1200
  • RAW WATER SEA STRAINER: Vetus seachest
  • FUEL FILTERS: USCG approved
  • FUEL SHUT OFF: manifold
  • HEAD TYPE: wilcox crittenden marine head
  • HOLDING TANK: holding tank with deck fitting and macerator
  • HEATER: Webasto diesel boiler system with registers in all cabins
  • PROPELLER: 3 blade bronze 13″
  • FULL SHAFT: 1 1/4″ with dripless packing
  • STEERING: wagner hydraulic helm
  • TRANSMISSION: Capitol Gears reversing gears
  • OTHER: New starting battery installed Jan 2014 and engine was ran up to temperature with no problems. Good raw water flow.

Sails and rigging

Sails are in very good condition with light used and no damage or repairs

  • MAIN: yes
  • JIB: yes
  • #1 GENOA: yes
  • STAYSAIL: yes
  • TYPES OF SAILS: dacron
  • TRAVELER: yes
  • ROLLER FURL: Profurl (not installed)
  • WINCHES: 2 lewmar
  • BOOM VANG: 4:1 with rubber snubber
  • MAST: extruded aluminum
  • STANDING RIGGGING: SS wire with open bodied turnbuckles and toggles
  • SPIN POLE: 4″

Deck and hull

Recessed Anchoring deck with windlass/capstan and chain locker, plumbed for saltwater washdown, all new in 2005

  • ANCHOR: 44LB Bruce with 300ft 3/16HT feet chain
  • WINDLASS: Lonfrans 1500 vertical w/capstan
  • BOW ROLLERS: yes
  • NAV LIGHTS: international rules
  • LIFELINES: coated stainless cable
  • GATES: port and stbd side
  • LADDER: custom SS stbd side
  • RAILS: integral
  • DECK WASH: in anchor well (plumbed)
  • DECK MATERIAL : 3/4″ teak over marine ply fastened from below, recaulked in 2005
  • OTHER : Custom SS outboard gallows at aft rail stbd side.


All cushions and covers new in 2005 covered with sunbrella material

  • DODGER: hard top with removeable clear panels and screens for nice ventilation while at anchor
  • COCKPIT: center cockpit with raised combings
  • BIMINI: fully enclosed bimini with romevable clear panels and screens that can be unzipped
  • HATCHES: Lewmar ocean series hatches new in 2005
  • GENOA: dacron in good condition
  • STAYSAIL: dacron in good condition
  • BUG SCREENS: bug screens for all port lights and cockpit enclosure


  • LIFESLING: yes
  • FLARES: expired
  • OTHER: items like flares, fire extinguishers and first aid kits should all be inspected and or replaced.

Additional Equipment

  • A full set of mechanics tools as well as woodworking tools are included. There are many spares along with hardware and equipment for future projects onboard. There is also a portable 110v air compressor and sanders/grinders.